Wiring guides

What size fuse and wire for marine electronics?

How to choose the fuse and the wire gauge for boat electronics: what the fuse protects, voltage drop, round-trip length and where the fuse goes.

Two rules that settle most of it

Wire gauge is about length

Thin wire on a long run loses voltage, and electronics are fussy about voltage. The usual marine target for electronics is no more than a 3 percent drop. To size the wire you need the current the device draws and the length of the run.

Measure the run there and back

The length that counts is the full circuit: from the power source to the device and back to the negative. A screen 12 feet from the fuse block is a 24 foot run. This is the mistake that leads to wire one or two sizes too small.

Where the fuse goes

At the supply end of the wire, as close to the power source as you can get it. The marine standard is within 7 inches in most cases. A fuse at the device end leaves the whole length of wire unprotected.

Use the right wire and ends

If you extend a supplied power cable

Many displays come with a power cable and an inline fuse. If the run is longer than that cable, the maker's instructions say which gauge to extend it with at each length. Follow that table, and keep the fuse at the supply end.

When to stop

Warm wires, melted insulation, a fuse that blows again, corrosion at a connection or anything you cannot identify are signs of a problem the new gear did not cause. Disconnect the battery and have it looked at before you add anything to it.

Want it drawn for your boat?

Tell us about your boat, what you want it to do and the brand you like. We pick the right gear and send back a wiring plan checked by an ABYC and NMEA certified marine electronics installer. Plans start at $149 and arrive in 3 business days.

Start my plan   See a sample plan